User's Manual
Table Of Contents
- Table of Contents
- List of Figures
- Introduction
- Installing the Wireless Array
- Installation Prerequisites
- Planning Your Installation
- Installation Workflow
- Installing Your Wireless Array
- Powering Up the Wireless Array
- Establishing Communication with the Array
- Entering the License
- Performing the Express Setup Procedure
- The Web Management Interface
- Viewing Status on the Wireless Array
- Configuring the Wireless Array
- Express Setup
- Network
- Services
- VLANs
- Tunnels
- Security
- SSIDs
- Groups
- IAPs
- WDS
- Filters
- Clusters
- Using Tools on the Wireless Array
Wireless Array
356 Configuring the Wireless Array
2. Select a WMI window for settings that you wish to configure for the
cluster, and proceed to make the desired changes.
3. Proceed to any additional pages where you wish to make changes.
4. Some Status and Statistics windows will present information for all
Arrays in the cluster.
5. Click the Save button when done if you wish to save changes on the
cluster member Arrays.
6. Exit: Click the Exit button to the right of the operating cluster to terminate
Cluster Mode. The WMI returns to normal operation — managing only
the Array to which it is connected.
Status and Statistics Windows in Cluster Mode
In Cluster Mode, many of the Status and Statistics windows will display
information for all of the members of the cluster. You can tell whether a window
displays cluster information — if so, it will display the Cluster Name near the top,
as shown in Figure 174.
Figure 174. Viewing Statistics in Cluster Mode
Cluster Name
Specify Grouping
Exit Cluster Mode