User's Manual
Table Of Contents
- Table of Contents
- List of Figures
- Introduction
- Installing the Wireless Array
- Installation Prerequisites
- Planning Your Installation
- Installation Workflow
- Installing Your Wireless Array
- Powering Up the Wireless Array
- Establishing Communication with the Array
- Entering the License
- Performing the Express Setup Procedure
- The Web Management Interface
- Viewing Status on the Wireless Array
- Configuring the Wireless Array
- Express Setup
- Network
- Services
- VLANs
- Tunnels
- Security
- SSIDs
- Groups
- IAPs
- WDS
- Filters
- Clusters
- Using Tools on the Wireless Array
Wireless Array
Configuring the Wireless Array 337
3. Roaming Threshold: This is the difference in signal strength between
radios that will trigger a deauthentication, as described in the discussion
above. In most cases, this will be a negative number.
Figure 161. Roaming Assist
4. Minimum Data Rate: If the station’s data rate (either Tx or Rx) falls
below this rate, it will trigger a deauthentication.
5. Device Classes and Device Types: You can configure the device classes
or types that will be assisted in roaming. Many small, embedded devices
(such as the default device types: phones, tablets, music players) are
sticky—they have high roaming thresholds that tend to keep them
attached to the same radio despite the presence of radios with better
signal strength. You may check off one or more entries, but use care since
roaming assist may cause poor results in some cases.