User's Manual

Table Of Contents

Wireless Array

334 Configuring the Wireless Array

LED Settings

This window assigns behavior preferences for the Array’s IAP LEDs.

Figure 159. LED Settings

Procedure for Configuring the IAP LEDs

1. LED State: This option determines which event triggers the LEDs, either

when an IAP is enabled or when an IAP first associates with the network.

Choose On Radio Enabled or On First Association, as desired. You may

also choose Disabled to keep the LEDs from being lit. The LEDs will still

light during the boot sequence, then turn off.

2. LED Blink Behavior: This option allows you to select when the IAP LEDs

blink, based on the activities you check here. From the choices available,

select one or more activities to trigger when the LEDs blink. For default

behavior, see “Array LED Operating Sequences” on page 64.

3. Click Save changes to flash if you wish to make your changes

permanent.