User's Manual
Table Of Contents
- Table of Contents
- List of Figures
- Introduction
- Installing the Wireless Array
- Installation Prerequisites
- Planning Your Installation
- Installation Workflow
- Installing Your Wireless Array
- Powering Up the Wireless Array
- Establishing Communication with the Array
- Entering the License
- Performing the Express Setup Procedure
- The Web Management Interface
- Viewing Status on the Wireless Array
- Configuring the Wireless Array
- Express Setup
- Network
- Services
- VLANs
- Tunnels
- Security
- SSIDs
- Groups
- IAPs
- WDS
- Filters
- Clusters
- Using Tools on the Wireless Array
Wireless Array
324 Configuring the Wireless Array
Figure 155. Hotspot 2.0 Settings
5. English/Chinese Operator Friendly Name. Enter an English or Chinese
name into one of the fields. An incorrectly entered name can be deleted
by clicking the corresponding Delete.
6. Connection Capabilities. A Hotspot 2.0 access point limits the particular
protocols that clients may use. The set of default protocols is shown
initially. This table specifies the protocols in terms of:
a. A common Name, such as FTP or HTTP.
b. A Protocol number. For example 1 for ICMP, 6 for TCP, 17 for UDP,
and 50 for Encapsulated Security Protocol in IPsec VPN connections.
c. Port number for UDP/TCP connection.