User's Manual

Table Of Contents

Wireless Array

278 Configuring the Wireless Array

For additional information about cell sizes, go to “Coverage and Capacity

Planning” on page 28.

7. If you are using WDS to provide backhaul over an extended distance, use

WDS Dist. (Miles) to prevent timeout problems associated with long

transmission times. Set the approximate distance in miles between this

IAP and the connected Array in this column. This increases the wait time

for frame transmission accordingly.

8. In the Antenna Select column, choose the antenna you want this radio to

use from the pull-down list. The list of available antennas will be different

(or no choices will be available), depending on the Array model and on

the wireless mode you selected for the IAP.

9. If desired, enter a description for this IAP in the Description field.

10. You may reset all of the enabled IAPs by clicking the Reset Channels

button at the bottom of the list. A message will inform you that all

enabled radios have been taken down and brought back up.

11. Buttons at the bottom of the list allow you to Enable All IAPs or Disable

All IAPs.

12. Click Save changes to flash if you wish to make your changes

permanent.