User's Manual
Table Of Contents
- Table of Contents
- List of Figures
- Introduction
- Installing the Wireless Array
- Installation Prerequisites
- Planning Your Installation
- Installation Workflow
- Installing Your Wireless Array
- Powering Up the Wireless Array
- Establishing Communication with the Array
- Entering the License
- Performing the Express Setup Procedure
- The Web Management Interface
- Viewing Status on the Wireless Array
- Configuring the Wireless Array
- Express Setup
- Network
- Services
- VLANs
- Tunnels
- Security
- SSIDs
- Groups
- IAPs
- WDS
- Filters
- Clusters
- Using Tools on the Wireless Array
Wireless Array
Configuring the Wireless Array 263
• Deny List: Denies the listed MAC addresses permission to
associate to the Array. All others are allowed.
3. MAC Address: If you want to add a MAC address to the ACL, enter the
new MAC address here, then click the Add button. The MAC address is
added to the ACL. You may use a wildcard (*) for one or more digits to
match a range of addresses. Delete: You may delete selected MAC
addresses from this list by clicking their Delete buttons.
4. Delete All: This button, on the upper left, may be used to delete all the
MAC entries in an ACL.
5. Click Save changes to flash if you wish to make your changes
permanent.
In addition to these lists, other authentication methods (for
example, RADIUS) are still enforced for users.