User's Manual
Table Of Contents
- Table of Contents
- List of Figures
- Introduction
- Installing the Wireless Array
- Installation Prerequisites
- Planning Your Installation
- Installation Workflow
- Installing Your Wireless Array
- Powering Up the Wireless Array
- Establishing Communication with the Array
- Entering the License
- Performing the Express Setup Procedure
- The Web Management Interface
- Viewing Status on the Wireless Array
- Configuring the Wireless Array
- Express Setup
- Network
- Services
- VLANs
- Tunnels
- Security
- SSIDs
- Groups
- IAPs
- WDS
- Filters
- Clusters
- Using Tools on the Wireless Array
Wireless Array
206 Configuring the Wireless Array
8. MTU: Set maximum transmission unit (MTU) size.
9. Interval: The tunnel mechanism will ping the current remote endpoint
periodically to ensure that it is still reachable. Enter the ping interval (in
seconds).
10. Failures: Enter the number of consecutive ping failures that will cause the
Array to consider the tunnel to be down.
11. Click Save changes to flash if you wish to make your changes
permanent.
12. Proceed to SSID Assignments to define the SSIDs (and associated
VLANs) for which each tunnel will bridge data. You may create up to 16
tunnels. Each will need an SSID/VLAN pair assigned to it so that it can
function properly.
SSID Assignments
This window allows you to select the SSIDs to be bridged by each tunnel.
Figure 120. Tunnel SSID Assignments
Procedure for Assigning SSIDs
This window lists the tunnels and SSIDs that you have defined. SSIDs to be
tunnelled should be associated with a VLAN (see “SSID Management” on
page 249).