User's Manual
Table Of Contents
- Table of Contents
- List of Figures
- Introduction
- Installing the Wireless Array
- Installation Prerequisites
- Planning Your Installation
- Installation Workflow
- Installing Your Wireless Array
- Powering Up the Wireless Array
- Establishing Communication with the Array
- Entering the License
- Performing the Express Setup Procedure
- The Web Management Interface
- Viewing Status on the Wireless Array
- Configuring the Wireless Array
- Express Setup
- Network
- Services
- VLANs
- Tunnels
- Security
- SSIDs
- Groups
- IAPs
- WDS
- Filters
- Clusters
- Using Tools on the Wireless Array
Wireless Array
172 Configuring the Wireless Array
On XN Series Arrays, this window configures the 10/100 Fast Ethernet interface
and the Gigabit 1 and Gigabit2 interfaces
When finished making changes, click Save changes to flash if you wish to make
your changes permanent. When the status of a port changes, a Syslog entry is
created describing the change.
Network Interface Ports
The following diagram shows the location of network interface ports on the
underside of an XR Series Array.
Figure 100. Network Interface Ports
Procedure for Configuring the Network Interfaces
Configure the Gigabit network interfaces (for XN Arrays, configure the Fast
Ethernet port as well). The fields for each of these interfaces are the same, and
include:
1. Enable Interface: Choose Yes to enable this network interface, or choose
No to disable the interface.
XR-6000 Series
Console
Gigabit1 POE
Gigabit2
Console
Gigabit1 POE
Gigabit2 POE
Gigabit3
Gigabit4
XR-4000 Series