User's Manual
Table Of Contents
- Table of Contents
- List of Figures
- Introduction
- Installing the Wireless Array
- Installation Prerequisites
- Planning Your Installation
- Installation Workflow
- Installing Your Wireless Array
- Powering Up the Wireless Array
- Establishing Communication with the Array
- Entering the License
- Performing the Express Setup Procedure
- The Web Management Interface
- Viewing Status on the Wireless Array
- Configuring the Wireless Array
- Express Setup
- Network
- Services
- VLANs
- Tunnels
- Security
- SSIDs
- Groups
- IAPs
- WDS
- Filters
- Clusters
- Using Tools on the Wireless Array
Wireless Array
146 Viewing Status on the Wireless Array
IDS Statistics
The Xirrus Array employs a number of IDS/IPS (Intrusion Detection System/
Intrusion Prevention System) strategies to detect and prevent malicious attacks on
the wireless network. This status-only window provides detailed intrusion
detection statistics for the selected IAP. Use the Display Averages checkbox at the
upper left to select the output format — check this option to express each statistic
as an average rate, or leave it blank to display raw counts.
Note that you must have Intrusion Detection Mode enabled to collect IDS
statistics. See “Intrusion Detection” on page 328. Information about IDS events is
discussed in the “IDS Event Log Window” on page 157
Figure 86. IDS Statistics Page
You can Refresh the data (update the window with the latest information) at any
time by clicking on the appropriate button. You can also click in the Auto Refresh
check box to instruct the Array to refresh this window automatically.
See Also
Intrusion Detection
IDS Event Log Window