User's Manual
Table Of Contents
- Table of Contents
- List of Figures
- Introduction
- Installing the Wireless Array
- Installation Prerequisites
- Planning Your Installation
- Installation Workflow
- Installing Your Wireless Array
- Powering Up the Wireless Array
- Establishing Communication with the Array
- Entering the License
- Performing the Express Setup Procedure
- The Web Management Interface
- Viewing Status on the Wireless Array
- Configuring the Wireless Array
- Express Setup
- Network
- Services
- VLANs
- Tunnels
- Security
- SSIDs
- Groups
- IAPs
- WDS
- Filters
- Clusters
- Using Tools on the Wireless Array
Wireless Array
Viewing Status on the Wireless Array 99
Figure 47. Disabled IAP (Partial View)
• Channel: Shows which channel each IAP is using, and the channel
setting. To avoid co-channel interference, adjacent radios should not
be using adjacent channels. To make channel selections for a specific
IAP, go to “IAP Settings” on page 274.
• Wi-Fi Mode: Shows the 802.11 client types that the IAP has been
configured to support.
• Antenna: Shows which antenna is being used by each IAP.
• Cell Size: Indicates which cell size setting is currently active for each
IAP — small, medium, large, max, automatic, or manually defined by
you. The cell size of an IAP is a function of its transmit power and
determines the IAP’s overall coverage. To define cell sizes, go to “IAP
Settings” on page 274. For additional information about cell sizes and
the importance of planning for and defining the optimum cell sizes
for your Array, go to “Coverage and Capacity Planning” on page 28.