User's Manual
Table Of Contents
- Table of Contents
- List of Figures
- Introduction
- Installing the Wireless Array
- Installation Prerequisites
- Planning Your Installation
- Installation Workflow
- Installing Your Wireless Array
- Powering Up the Wireless Array
- Establishing Communication with the Array
- Entering the License
- Performing the Express Setup Procedure
- The Web Management Interface
- Viewing Status on the Wireless Array
- Configuring the Wireless Array
- Express Setup
- Network
- Services
- VLANs
- Tunnels
- Security
- SSIDs
- Groups
- IAPs
- WDS
- Filters
- Clusters
- Using Tools on the Wireless Array
Wireless Array
Installing the Wireless Array 81
off disables both CLI and XBL access
aos-only enables only CLI (i.e. ArrayOS) access
boot-only enables only XBL access
Note that there is a WMI setting for changing Xircon access, timeout
period, and the UDP port used. This may be used instead of CLI if you
wish. See “Management Control” on page 221. Note that you cannot
change the XBL username and password via the WMI.