User's Manual

Wireless Array
80 Installing the Wireless Array
1. To access CLI via the WMI, click CLI under the Tools section on the left
(for detailed instructions see “CLI” on page 371). Skip to Step 4 on
page 80.
To access CLI via SSH, see “Establishing a Secure Shell (SSH)
Connection” on page 377. Then proceed to the next step.
2. At the login as prompt, log in to CLI using the username and password
that you set in Step 10 on page 75.
login as: jsmith
jsmith@xr4012802207c's password:
Xirrus Wi-Fi Array
ArrayOS Version 6.1.2-3299
Copyright (c) 2005-2012 Xirrus, Inc.
http://www.xirrus.com
XR4012802207C#
3. Type configure to enter the CLI config mode.
hostname#configure
4. If Xircon access at the XBL level is to be allowed, use the following three
commands to change the XBL username and password from the default
values of admin/admin. In the example below, replace newusername
and newpassword with your desired entries. Note that these entries are
case-sensitive.
(config)#boot-env set username newusername
(config)#boot-env set password newpassword
(config)#save
5. Enter the following commands if you wish to change Xircon access
permission:
(config)# management
(config-mgmt)# xircon <management-status>
(config-mgmt)# save
(config-mgmt)# exit
(config)#
<management-status>
may be one of :
 on enables both CLI and XBL access