User's Manual

XR300 Series Notices and Regulatory Guide
2
Use of a shielded twisted pair (STP) cable must be used for all Ethernet connections in order to comply with EMC
requirements.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Operations in the 5.15-5.25GHz band are restricted to indoor usage only.
Non-Modification Statement
Unauthorized changes or modifications to the device are not permitted. Use only the supplied internal antenna, or
external antennas supplied by the manufacturer. Modifications to the device will void the warranty and may
violate FCC regulations.
Cable Runs for Power over Gigabit Ethernet (PoGE)
If using PoGE, the AP must be connected to PoGE networks without routing cabling to the outside plant — this
ensures that cabling is not exposed to lightning strikes or possible cross over from high voltage.
Battery Warning
UL Statement
Use only with listed ITE product.
RF Radiation Hazard Warning
To ensure compliance with FCC and Industry Canada RF exposure requirements, this device must be installed in a
location where the antennas of the device will have a minimum distance of at least 30 cm (12 inches) from all
persons. Using higher gain antennas and types of antennas not certified for use with this product is not allowed.
The device shall not be co-located with another transmitter.
Installez l'appareil en veillant à conserver une distance d'au moins 30 cm entre les éléments rayonnants et les
personnes. Cet avertissement de sécurité est conforme aux limites d'exposition définies par la norme CNR-102 at
relative aux fréquences radio.
Industry Canada Statement
This device complies with RSS-210 of the Industry Canada Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Ce dispositif est conforme à la norme CNR-210 d'Industrie Canada applicable aux appareils radio exempts de
licence. Son fonctionnement est sujet aux deux conditions suivantes: (1) le dispositif ne doit pas produire de
brouillage préjudiciable, et (2) ce dispositif doit accepter tout brouillage reçu, y compris un brouillage susceptible
de provoquer un fonctionnement indésirable.
!
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate this equipment.
!
Caution! The AP contains a battery which is not to be replaced by the customer. Danger of Explosion exists if
the battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the
manufacturer. Dispose of used batteries according to the manufacturer's instructions.