User's Guide

Wireless Array
Installing the Wireless Array 25
Installing the Wireless Array
The instructions for completing a successful installation include the following
topics:
z
“Installation Prerequisites” on page 25.
z
“Planning Your Installation” on page 28.
z
“Installation Workflow” on page 58.
z
“Installing Your Wireless Array” on page 60.
z
“Powering Up the Wireless Array” on page 64.
z
“Establishing Communication” on page 67.
z
“Performing the Express Setup Procedure” on page 72.
Installation Prerequisites
Your Wireless Array deployment requires the presence of hardware and services
in the host wired/wireless network, including:
z
Power Source
Xirrus Arrays and APs are powered via Xirrus-supplied Power over
Gigabit Ethernet. PoGE supplies power over the same Cat 5e or Cat 6
cable used for data, thus reducing cabling and installation effort. PoGE
power injector modules are available in 1-, 2-, and 8-port configurations
and are typically placed near your Gigabit Ethernet switch. An AC outlet
is required for each injector module.
Some smaller Arrays and APs are compatible with IEEE802.3af and/or
IEEE802.3at, and may be connected to appropriate powered switches. For
example, the Xirrus XT-5024 is a 24-port 802.3at POE+ managed switch.
See the Quick Installation Guide for the Array/AP for compatible
injectors or powered switches.
z
Ethernet ports
You need at least one 100/1000 BaseT port to establish wired Gigabit
Ethernet connectivity. XR Series Arrays have one, two, or four Gigabit