User Guide Part 2

Wi-Fi Array

Configuring the Wi-Fi Array 255

IAP Settings

This window allows you to enable/disable IAPs, define the wireless mode for

each IAP, specify the channel to be used and the cell size for each IAP, lock the

channel selection, establish transmit/receive parameters, select antennas, and

reset channels. Buttons at the bottom of the list allow you to Reset Channels,

Enable All IAPs, or Disable All IAPs. When finished, click on the Apply button

to apply the new settings to this session, or click Save to apply your changes and

make them permanent. To see a diagram of the layout and naming of IAPs, go to

Figure 7 on page 16.

Figure 138. IAP Settings

You may also access this window by clicking on the Array image at the lower left

of the WMI window—click the orange Xirrus logo in the center of the Array. See

“User Interface” on page 123.

Procedure for Auto Configuring IAPs

You can auto-configure channel and cell size of radios by clicking on the Auto

Configure buttons on the relevant WMI page (auto configuration only applies to

enabled radios):

For all radios, go to “Advanced RF Settings” on page 275.

For all 802.11a settings, go to “Global Settings .11a” on page 267.