User Guide Part 2

Wi-Fi Array

Appendix E: Implementing FIPS Security 427

• XS4 or XS-3500—Apply two seals, one on either side of the Array

about 180° apart from each other, as shown. IMPORTANT: Make

sure that each seal straddles a seam.

Figure 191. Applying Two Tamper-evident seals to the XS4 or XS-3500

2. Enable HTTPS using the CLI if it is not already enabled, using the

following command:

Xirrus_Wi-Fi_Array(config)# https on

This allows the Web Management Interface to be used for the rest of this

procedure. HTTPS is enabled on Arrays by default.