User Guide Part 1

Wi-Fi Array
Viewing Status on the Wi-Fi Array 129
• Status: Shows the current state of each interface, either enabled or
disabled.
• Link: Shows whether the link on this interface is up or down.
• DHCP: Shows whether DHCP on this port is enabled or disabled.
• IP Address: Shows the current IP address assigned to each network
interface device.
• Subnet Mask: Shows the subnet mask, which defines the number of
IP addresses that are available on the routed subnet where the Array
is located.
• Gateway: Shows the IP address of the router that the Array uses to
transmit data to other networks.
z
Integrated Access Points Section
This section provides information about the Integrated Access Points
(IAPs) that are contained within the Array. How many IAPs are listed
depends on which product model you are using (16 IAPs for the XN16,
XS16, or XS-3900, 12 IAPs for the XN12, or XS12, 8 IAPs for the XN8, XS8,
or XS-3700, and 4 IAPs for the XN4, XS4 or XS-3500). To make
configuration changes to these IAPs, go to “IAP Settings” on page 255.
• IAP: Lists the IAPs that are available on the Array.
• State: Shows the current state of each IAP, either up or down. IAPs
that are down are shown in RED. Figure 66 shows an example where
IAP a3 is down.
Figure 66. Disabled IAP (Partial View)