User Guide

Wi-Fi Array

Configuring the Wi-Fi Array 293

8. QoS: (Optional) Set packets that match the filter criteria to this QoS level

(0 to 3) from the pull-down list. Level 0 has the lowest priority; level 3 has

the highest priority. By default, this field is blank and the filter does not

modify QoS level. See “Understanding QoS Priority on the Wi-Fi Array”

on page 235.

9. VLAN ID: (Optional) Set packets that match the filter criteria to this

VLAN. Select a VLAN from the pull-down list, or select numeric and

enter the number of a previously defined VLAN (see “VLANs” on

page 203).

10. Move Up/Down: The filters are applied in the order in which they are

displayed in the list, with filters on the top applied first. To change an

entry’s position in the list, just click its Up or Down button.

11. Source Address: Define a source address to match as a filter criterion.

Click the radio button for the desired type of address (or other attribute)

to match. Then specify the value to match in the field to the right of the

button. Choose Any to use any source address. Check Not to match any

address except for the specified address.

12. Destination Address: Define a destination address to match as a filter

criterion. Click the radio button for the desired type of address (or other

attribute) to match. Then specify the value to match in the field to the

right of the button. Choose Any to use any source address. Check Not to

match any address except for the specified address.

13. To delete a filter, check its Delete checkbox, then click the Apply or Save

button.

14. Click on the Apply button to apply your changes to the selected filter, or

click Save to apply your changes and make them permanent.