User Guide

Wi-Fi Array
286 Configuring the Wi-Fi Array
The configuration for WDS is performed on the client Array only, as described in
“WDS Client Links” on page 287. No WDS configuration is performed on the host
Array. First you will set up a client link, defining the target (host) Array and SSID,
and the maximum number of IAPs in the link. Then you will select the IAPs to be
used in the link. When the client link is created, each member IAP will associate to
an IAP on the host Array.
Figure 147. .Configuring a WDS Link
See Also
SSID Management
WDS Client Link IAP Assignments:
WDS Client Links
WDS Statistics
#
Once an IAP has been selected to act as a WDS client link, you will not be
allowed to use auto-configured cell sizing on that IAP (since the cell must
extend all the way to the other Array).
a2(52)
a3(149)
a4(40)
a10(52)
a9(149)
a8(40)
CLIENT HOST
Wired LAN
Client
Link