User Guide

Wi-Fi Array

Configuring the Wi-Fi Array 283

LED Settings

This window assigns behavior preferences for the Array’s IAP LEDs.

Figure 145. LED Settings

Procedure for Configuring the IAP LEDs

1. LED State: This option determines which event triggers the LEDs, either

when an IAP is enabled or when an IAP first associates with the network.

Choose On Radio Enabled or On First Association, as desired. You may

also choose Disabled to keep the LEDs from being lit. The LEDs will still

light during the boot sequence, then turn off.

2. LED Blink Behavior: This option allows you to select when the IAP LEDs

blink, based on the activities you check here. From the choices available,

select one or more activities to trigger when the LEDs blink.

See also, “Array LED Operating Sequences” on page 108.

3. Click on the Apply button to apply the new settings to this session, or

click Save to apply your changes and make them permanent.