User Guide

Wi-Fi Array
Configuring the Wi-Fi Array 257
• -1—This channel is bonded to the next lower channel number. Auto
Channel bonding does not apply.
5. Click the Lock check box if you want to lock in your channel selection so
that the autochannel operation (see Advanced RF Settings) cannot change
it.
6. In the Cell Size column, select Auto to allow the optimal cell size to be
automatically computed (see also, Step 8 on page 279). To set the cell size
yourself, choose either Small, Medium, Large, or Max to use the desired
pre-configured cell size, or choose Manual to define the wireless cell size
manually. If you choose Manual, you must specify the transmit and
receive power—in dB—in the Tx dBm (transmit) and Rx dBm (receive)
fields. The default is Max.
When other Arrays are within listening range of this one, setting cell sizes
to Auto allows the Array to change cell sizes so that coverage between
cells is maintained. Each cell size is optimized to limit interference
between sectors of other Arrays on the same channel. This eliminates the
need for a network administrator to manually tune the size of each cell
when installing multiple Arrays. In the event that an Array or a radio
goes offline, an adjacent Array can increase its cell size to help
compensate.
The number of users and their applications are major drivers of
bandwidth requirements. The network architect must account for the
number of users within the Array’s cell diameter. In a large office, or if
multiple Arrays are in use, you may choose Small cells to achieve a
higher data rate, since walls and other objects will not define the cells
naturally.
For additional information about cell sizes, go to “Coverage and Capacity
Planning” on page 50.
7. In the Antenna Select column, choose the antenna you want this radio to
use from the pull-down list. The list of available antennas will be different
(or no choices will be available), depending on the wireless mode you
selected for the IAP.