User Guide

Wi-Fi Array
254 Configuring the Wi-Fi Array
IAP Settings
This window allows you to enable/disable IAPs, define the wireless mode for
each IAP, specify the channel to be used and the cell size for each IAP, lock the
channel selection, establish transmit/receive parameters, select antennas, and
reset channels. Buttons at the bottom of the list allow you to Reset Channels,
Enable All IAPs, or Disable All IAPs. When finished, click on the Apply button
to apply the new settings to this session, or click Save to apply your changes and
make them permanent. To see a diagram of the layout and naming of IAPs, go to
Figure 7 on page 16.
Figure 139. IAP Settings
You may also access this window by clicking on the Array image at the lower left
of the WMI window—click the orange Xirrus logo in the center of the Array. See
“User Interface” on page 123.