User Guide

Wi-Fi Array
236 Configuring the Wi-Fi Array
possible user priority levels and the Array implements four wireless QoS levels,
user priorities are mapped to QoS as described below.
End-to-End QoS Handling
z Wired QoS - Ethernet Port:
Ingress: Incoming wired packets are assigned QoS priority based on their
SSID and 802.1p tag (if any), as shown in the table below. This table
follows the mapping recommended by IEEE802.11e.
FROM
Priority Tag
802.1p (Wired)
TO
Array QoS
(Wireless)
Typical Use
0 (Default) 0 (Lowest
priority)
Best Effort
1 1 Background—explicitly designated as
low-priority and non-delay sensitive
21Spare
3 0 Excellent Effort
42Controlled Load
52Video
6 3 Voice - requires delay <10ms
7 (Highest
priority)
3 (Highest
priority)
Network control