User Guide

Wi-Fi Array
218 Configuring the Wi-Fi Array
Procedure for Configuring Management Control
1. SSH:
a. Enable Management: Choose Yes to enable management of the
Array over a Secure Shell (SSH-2) connection, or No to disable this
feature. Be aware that only SSH-2 connections are supported by the
Array. SSH clients used for connecting to the Array must be
configured to use SSH-2.
b. Connection Timeout 30-100000 (Seconds): Enter a value in this field
to define the timeout (in seconds) before your SSH connection is
disconnected. The value you enter here must be between 30 seconds
and 100,000 seconds.
c. Port: Enter a value in this field to define the port used by SSH.
The default port is 22.
2. Telnet:
a. Enable Management: Choose Yes to enable Array management over
a Telnet connection, or No to disable this feature. SSH offers a more
secure connection than Telnet, and is recommended over Telnet.
b. Connection Timeout 30-100000 (Seconds): Enter a value in this field
to define the timeout (in seconds) before your Telnet connection is
disconnected. The value you enter here must be between 30 seconds
and 100,000 seconds.
c. Port: Enter a value in this field to define the port used by Telnet.
The default port is 23.
3. Serial
a. Enable Management: Choose Yes to enable management of the
Array via a serial connection, or choose No to disable this feature.
b. Connection Timeout 30-100000 (Seconds): Enter a value in this field
to define the timeout (in seconds) before your serial connection is
disconnected. The value you enter here must be between 30 seconds
and 100,000 seconds.