User Guide

Wi-Fi Array

Appendix D: Implementing Security Standards 423

To implement FIPS 140-2, Level 2 using WMI

1. Apply the supplied tamper-evident seals to the unit as indicated in the

figures below. The procedure is slightly different, depending on the

model.

• Before you apply the tamper-evident seal, clean the area of any

grease, dirt, or oil. We recommend using alcohol-based cleaning pads

for this.

• Each seal must be applied to straddle both sides of an opening so that

it will show if an attempt has been made to open the Array.

• XS16, XS12, XS8, XS-3900, or XS-3700—Apply two seals, one on either

side of the Array about 180° apart from each other, as shown. Apply a

third seal to the access panel opening, as shown. IMPORTANT:

Make sure that each seal straddles a seam.

Figure 191. Applying Three Seals to the XS16/XS12/XS8 or XS-3900/XS-3700