User Guide

Wi-Fi Array
192 Configuring the Wi-Fi Array
Time Settings (NTP)
This window allows you to manage the Array’s time settings, including
synchronizing the Array’s clock with a universal clock from an NTP (Network
Time Protocol) server. Synchronizing the Array’s clock with an NTP server
ensures that Syslog time-stamping is maintained across all units.
Figure 114. Time Settings (Manual Time)
Procedure for Managing the Time Settings
1. Time Zone: Select the time zone you want to use (normally your local
time zone) from the pull-down list.
2. Auto Adjust Daylight Savings: Check this box if you want the system to
adjust for daylight savings automatically, otherwise leave this box
unchecked (default).
3. Use Network Time Protocol: select whether to set time manually or use
NTP to manage system time.
4. Setting Time Manually
a. Adjust Time (hrs:min:sec): If you are not using NTP, check this box if
you want to adjust the current system time. When the box is checked,
the time fields become active. Enter the revised time (hours, minutes,
seconds, am/pm) in the corresponding fields. If you don’t want to
adjust the current time, this box should be left unchecked (default).