User Guide

Wi-Fi Array
182 Configuring the Wi-Fi Array
When finished making changes, click on the Apply button to apply the new
settings to this session, or click Save to apply your changes and make them
permanent. When the status of an Ethernet or Gigabit port changes, a Syslog entry
is created describing the change.
Network Interface Ports
The following diagram shows the location of each network interface port on the
underside of the Array.
Figure 107. Network Interface Ports
Procedure for Configuring the Network Interfaces
Configure the Fast Ethernet and Gigabit 1 network interfaces (some Gigabit 2
settings cannot be configured separately and will mirror Gigabit 1). The fields for
each of these interfaces are the same, and include:
#
Gigabit 2 settings will “mirror” Gigabit 1 settings (except for MAC
addresses) and cannot be configured separately.
Serial
Fast Ethernet
Gigabit 1
Gigabit 2