User Guide

Wi-Fi Array
Configuring the Wi-Fi Array 173
Configuring the Wi-Fi Array
The following topics include procedures for configuring the Array using the
product’s embedded Web Management Interface (WMI). Procedures have been
organized into functional areas that reflect the flow and content of the WMI.
The following WMI windows allow you to establish configuration parameters for
your Array, and include:
z “Express Setup” on page 174
z “Network” on page 180
z “Services” on page 191
z “VLANs” on page 203
z “Security” on page 207
z “SSIDs” on page 233
z “Groups” on page 245
z “IAPs” on page 252
z “WDS” on page 285
z “Filters” on page 289
After making changes to the configuration settings of an Array you must click on
the Save button at the bottom of the configuration window, otherwise the changes
you make will not be applied the next time the Array is rebooted. Click the Apply
button if you want the changes applied to the current configuration, without
making them permanent.
This chapter only discusses using the configuration windows on the Array. To
view status or use system tools on the Array, please see:
z “Viewing Status on the Wi-Fi Array” on page 127
z “Using Tools on the Wi-Fi Array” on page 295