User Guide

Wi-Fi Array
Viewing Status on the Wi-Fi Array 129
Content of the Array Summary Window
The Array Summary window is sub-divided into the Ethernet Interfaces section
and the Integrated Access Points (radio) section, providing you with the
following information:
z Ethernet Interfaces Section
This section provides information about network interface devices. To
make configuration changes to these devices, go to “Network Interfaces”
on page 181.
• Interface: Lists the network interfaces that are available on the Array
(10/100 Ethernet 0, Gigabit Ethernet 1 and Gigabit Ethernet 2).
• Status: Shows the current state of each interface, either enabled or
disabled.
• Link: Shows whether the link on this interface is up or down.
• DHCP: Shows whether DHCP on this port is enabled or disabled.
• IP Address: Shows the current IP address assigned to each network
interface device.
• Subnet Mask: Shows the subnet mask, which defines the number of
IP addresses that are available on the routed subnet where the Array
is located.
• Gateway: Shows the IP address of the router that the Array uses to
transmit data to other networks.
z Integrated Access Points Section
This section provides information about the Integrated Access Points
(IAPs) that are contained within the Array. How many IAPs are listed
depends on which product model you are using (16 IAPs for the XN16,
XS16, or XS-3900, 12 IAPs for the XN12, or XS12, 8 IAPs for the XN8, XS8,
or XS-3700, and 4 IAPs for the XN4, XS4 or XS-3500). To make
configuration changes to these IAPs, go to “IAP Settings” on page 254.
• IAP: Lists the IAPs that are available on the Array.