User Guide

Wi-Fi Array

98 Installing the Wi-Fi Array

Install the SNAPTOGGLE™ Toggle Bolts

2. At the locations you marked in Step 1, drill a 1/2 inch (13mm) hole (there

must be a minimum clearance behind the wall of 1 7/8 inches—48mm).

3. (Refer to Figure 48, graphic A) Hold the metal channel flat alongside the

plastic straps and slide the channel through the hole.

Figure 48. Installing the Toggle Bolts

4. (Refer to Figure 48, graphic B) Hold the strap handle between your

thumb and forefinger and pull towards you until the metal channel rests

flush behind the wall.

Using your other hand, now slide the plastic cap along the straps until the

flange of the cap is flush with wall.

The straps provide a one-way ratcheting mechanism (similar to a cable tie).

Ensure that the toggle bolt assembly is oriented correctly (as shown) before

sliding the plastic cap along the straps.

5. (Refer to Figure 48, graphic C) Break the straps at the wall, flush with the

flange of the cap. The straps can be broken by pushing them from side-to-

side and simply snapping them off.

Figure 48, Graphic D shows a cutaway example of how the toggle bolt is

used to secure an item to the wall (in our case, the item is the Wall

Mounting Bracket—secured to the wall with 5 toggle bolts.

Do not attach the Wall Mounting Bracket to the wall at this time.

C D