User Guide

Wi-Fi Array
Installing the Wi-Fi Array 91
z Connect the supplied 6” orange Cat 5e data cable from the Array’s Data
OUT port to Gigabit1, as shown. Connect any additional Ethernet and
serial cables as required.
For the XS4:
Feed the PoGE cable through the access hole in the ceiling tile and the mounting
plate, then connect the cable to the Gigabit1 port on the XS4 Array. The Gigabit1
port is the data and management connection to the Array. A splitter is integrated
with this port.
Figure 42. Connecting the Cable (PoGE—XS4)
#
Do not connect the cable from the injector directly to a Gigabit port! It must
be connected to the
IN port (towards the right in Figure 41).
Connect Cat5e
(from PoGE
Injector)
to GIGABIT1
XS4