User Guide

Wi-Fi Array
86 Installing the Wi-Fi Array
Mounting the Array on a Ceiling
Most offices have drop-down acoustical ceiling tiles set into a standard grid. The
Wi-Fi Array has been designed to enable mounting to a tiled ceiling via a
mounting plate and clamps that attach to the grid. Once the mounting plate is
attached, the Array simply rotates onto the plate (similar to a smoke detector).
Once the unit is mounted it can be removed and re-attached easily, without the
need for tools or modifications to the original installation.
This section assumes that you are mounting the Array to a tiled ceiling. If your
ceiling is not tiled, the mounting plate can be attached directly to the ceiling with
the screws and anchors provided (without using the tile grid mounting clamps).
Attaching the T-Bar Clips to the Template
.
Figure 37. Attaching the T-Bar Clips to the Template
The T-bar clips create four mounting points on the ceiling tile grid for the Array
mounting plate. Use the mounting template (provided) to find the correct location
for all four clamps by pre-loading the 4 T-bar clips through the holes in the
mounting template. Twist the clips until they are correctly aligned with the
markings on the template.