User Manual Part 2

Wi-Fi Array
268 Configuring the Wi-Fi Array
IAPs
This status-only window summarizes the status of the Integrated Access Points
(radios). For each IAP, it shows whether it is up or down, the channel and Wi-Fi
mode, the antenna that it is currently using, its cell size and transmit and receive
power, how many users (stations) are currently associated to it, whether it is part
of a WDS link, and its MAC address.
Figure 126. IAPs
The Channel column displays some status information that is not found
elsewhere: the source of a channel setting. (Figure 127) If you set a channel
manually (via IAP Settings), it will be labeled as manual next to the channel
number (Figure 127). If an autochannel operation changed a channel, then it is
labeled as auto. If the channel is set to the current factory default setting, the
source will be default. This column also shows whether the channel selection is
locked, or whether the IAP was automatically switched to this channel because
the Array detected the signature of military radar in operation on a conflicting
channel.