User Manual Part 2

Wi-Fi Array
Configuring the Wi-Fi Array 223
Procedure for Configuring Management Control
1. Management Settings:
a. Failed login retry period (0-65535 seconds): After three consecutive
failing administrator login attempts via ssh or telnet, the
administrator’s IP address is denied access to the array for the
specified period of time (in seconds). The default is 0.
b. Pre-login Banner: Text that you enter here will be displayed above
the WMI login prompt. (Figure 110) You may enter up to ??xxx
characters??.
Figure 110. Pre-login Banner
c. Post-login Banner: Text that you enter here will be displayed in a
message box after a user logs in to the WMI. You may enter up to
??xxx characters??.
2. SSH:
a. On/Off: Choose On to enable management of the Array over a Secure
Shell (SSH-2) connection, or Off to disable this feature. Be aware that
only SSH-2 connections are supported by the Array. SSH clients used
for connecting to the Array must be configured to use SSH-2.
b. Connection Timeout 30-100000 (Seconds): Enter a value in this field
to define the timeout (in seconds) before your SSH connection is
disconnected. The value you enter here must be between 30 seconds
and 100,000 seconds.