User Manual Part 2

Wi-Fi Array

465

To implement FIPS 140-2, Level 2 using CLI:

1. The following CLI command will perform all of the settings required to

put the Array in FIPS mode:.

Xirrus_Wi-Fi_Array(config}# management

Xirrus_Wi-Fi_Array(config-mgmt}# fips on

Use the save command to save these changes to flash memory.

2. Use the fips off command if you wish to stop enforcing FIPS security

requirements on the Array.

Xirrus_Wi-Fi_Array(config-mgmt}# fips off

Use the save command to save these changes to flash memory.