User Manual Part 2

Wi-Fi Array
464
3. Select the Security > Management Control window. Set FIPS 140-2,
Level 2 Security to On (Figure 190 ). Click Apply, then Save.
Figure 190. Security - Management Control Window
4. You may now proceed to define SSIDs, as described in “SSIDs” on
page 243.
To check if an Array is in FIPS mode:
You may determine whether or not the Array is running in FIPS mode by opening
the Security > Management Control window and verifying that FIPS 140-2,
Level 2 Security is On (Figure 190 ).

The following steps must be performed in the order shown — you must
enable FIPS 140-2 before you create SSIDs. Otherwise, FIPS mode will
change the PSK keys of SSIDs, and you will not know what the keys are.