User Manual Part 2

Wi-Fi Array
Using Tools on the Wi-Fi Array 337
config-iap. The prompt will indicate the current command mode, for
example:
My-Array(config-iap) # 
 You can abbreviate a command and it will be executed if you have typed
enough of the command to be unambiguous. The command will not
auto-complete, however. Only the abbreviated command that you
actually typed will be shown. You can type a partial command and press
Tab to have the command auto-complete. If the partial command is
ambiguous a list of legal endings is displayed.
 Entering quit will return you to the previously viewed WMI page.
 Most, but not all, CLI commands can be run in this window. Specifically
the run-test menu of commands is not available in this window. To use
the run-test command, please connect using SSH and use CLI directly, or
use the System Tools described in this chapter, such as Trace Route, Ping,
and RADIUS Ping.
Help commands (the ? character) are available, either at the prompt or after you
have typed part of a command.
Options
This window allows you to customize the behavior and appearance of the WMI.
Figure 155. WMI Display Options