User Manual Part 2

Wi-Fi Array
Configuring the Wi-Fi Array 319
Cluster Operation
This window puts WMI into Cluster Mode. In this mode, all configuration
operations that you execute in WMI or CLI are performed on the members of the
cluster. They are not performed on the Array where you are running WMI, unless
it is a member of the cluster.
You must use the Apply and Save buttons at the bottom of configuration
windows to apply your changes in Cluster Mode, just as you would in normal
operation. When you are done configuring Arrays in the cluster, return to this
window and click the Exit button to leave Cluster Mode.
Figure 144. Cluster Mode Operation
Procedure for Operating in Cluster Mode
1. Operate: Click the Operate button to the right of the desired cluster. A
message informs you that you are operating in cluster mode. Click OK.
The Operate button is replaced with an Exit button.
Figure 145. Cluster Mode Activation