User Manual Part 2

Wi-Fi Array
314 Configuring the Wi-Fi Array
filter in a different filter list. Two filters with the same name in different
filter lists will be completely unrelated to each other — they may be
defined with different parameter values.
3. Filter: Choose a filter entry to modify from the list at the top of the
window.
4. On: Use this field to enable or disable this filter.
5. Deny: Choose whether this filter will be an Allow filter or a Deny filter. If
you define the filter as an Allow filter, then any associations that meet the
filter criteria will be allowed. If you define the filter as a Deny filter, any
associations that meet the filter criteria will be denied.
6. Protocol: Choose a specific filter protocol from the pull-down list, or
choose numeric and enter a Number, or choose any to instruct the Array
to use the best filter. This is a match criterion.
7. Port: This is a match criterion. From the pull-down list, choose the target
port type for this filter. Choose any to instruct the Array to apply the filter
to any port, or choose 1-65534 and enter a Number.
To enter a Range of port numbers,
separate the start and end numbers with
a colon as shown: Start # : End #.
8. QoS: (Optional) Set packets that match the filter criteria to this QoS level
(0 to 3), selected from the pull-down list. Level 0 has the lowest priority;
level 3 has the highest priority. By default, this field is blank and the filter
does not modify QoS level. See “Understanding QoS Priority on the Wi-Fi
Array” on page 245.
9. VLAN ID: (Optional) Set packets that match the filter criteria to this
VLAN. Select a VLAN from the pull-down list, or select numeric and
enter the number of a previously defined VLAN (see “VLANs” on
page 205).
10. Move Up/Down: The filters are applied in the order in which they are
displayed in the list, with filters on the top applied first. To change an
entry’s position in the list, just click its Up or Down button.