User Manual Part 2

Wi-Fi Array
Configuring the Wi-Fi Array 303
LED Settings
This window assigns behavior preferences for the Array’s IAP LEDs.
Figure 134. LED Settings
Procedure for Configuring the IAP LEDs
1. LED State: This option determines which event triggers the LEDs, either
when an IAP is enabled or when an IAP first associates with the network.
Choose On Radio Enabled or On First Association, as desired. You may
also choose Disabled to keep the LEDs from being lit. The LEDs will still
light during the boot sequence, then turn off.
2. LED Blink Behavior: This option allows you to select when the IAP LEDs
blink, based on the activities you check here. From the choices available,
select one or more activities to trigger when the LEDs blink. For default
behavior, see “Array LED Operating Sequences” on page 101.
3. Click on the Apply button to apply the new settings to this session, or
click Save to apply your changes and make them permanent.