User Manual Part 2

Wi-Fi Array
296 Configuring the Wi-Fi Array
Procedure for Configuring Advanced RF Settings
RF Intrusion Detection
1. Intrusion Detection Mode: This option allows you to choose the
Standard intrusion detection method, or you can choose Off to disable
this feature. See “Array Monitor and Radio Assurance Capabilities” on
page 440 for more information.
• Standard — enables the abg(n)2 radio as a monitor which collects
Rogue AP information.
• Off — IAP abg(n)2 does not function as a monitor.
2. Auto Block Unknown Rogue APs: Enable or disable auto blocking (see
“About Blocking Rogue APs” on page 295). Note that in order to set Auto
Block RSSI and Auto Block Level, you must set Auto Block Unknown
Rogue APs to On, and click Apply. Then the remaining Auto Block fields
will be active.
3. Auto Block RSSI: Set the minimum RSSI for rogue APs to be blocked.
APs with lower RSSI values will not be blocked. They are assumed to be
farther away, and probably belonging to neighbors and posing a minimal
threat.
4. Auto Block Level: Select rogue APs to block based on the level of
encryption that they are using. The choices are:
• Automatically block unknown rogue APs regardless of encryption.
• Automatically block unknown rogue APs with no encryption.

Some of the features below, such as Auto Configure for Cell Size and
Channel Configuration, are only available if the Array’s license includes the
Xirrus Advanced RF Performance Manager (RPM). If a setting is
unavailable (grayed out), then your license does not support the feature.
Please see “About Licensing and Upgrades” on page 325.
Other features below, such as RF Intrusion Detection, are only available if
the Array’s license includes the Xirrus Advanced RF Security Manager
(RSM).