User Manual Part 2

Wi-Fi Array

Configuring the Wi-Fi Array 275

The number of users and their applications are major drivers of

bandwidth requirements. The network architect must account for the

number of users within the Array’s cell diameter. In a large office, or if

multiple Arrays are in use, you may choose Small cells to achieve a

higher data rate, since walls and other objects will not define the cells

naturally.

For additional information about cell sizes, go to “Coverage and Capacity

Planning” on page 62.

7. In the Antenna Select column, choose the antenna you want this radio to

use from the pull-down list. The list of available antennas will be different

(or no choices will be available), depending on the wireless mode you

selected for the IAP.

8. If desired, enter a description for this IAP in the Description field.

9. You may reset all of the enabled IAPs by clicking the Reset Channels

button at the bottom of the list. A message will inform you that all

enabled radios have been taken down and brought back up.

10. Buttons at the bottom of the list allow you to Enable All IAPs or Disable

All IAPs.

11. Click on the Apply button to apply the new settings to this session, or

click Save to apply your changes and make them permanent.