Manual Part 2

Wireless Array
234 Configuring the Wireless Array
Access Control List
This window allows you to enable or disable the use of the global Access Control
List (ACL), which controls whether a station with a particular MAC address may
associate to the Array. You may create station access control list entries and delete
existing entries, and control the type of list.
There is only one global ACL, and you may select whether its type is an Allow
List or a Deny List, or whether use of the list is disabled.
There is also a per-SSID ACL (see “Per-SSID Access Control List” on page 276). If
the same MAC address is listed in both the global ACL and in an SSID’s ACL, and
if either ACL would deny that station access to that SSID, then access will be
denied.
Figure 133. Access Control List
Procedure for Configuring Access Control Lists
1. Access Control List Type: Select Disabled to disable use of the Access
Control List, or select the ACL type — either Allow List or Deny List.
• Allow List: Only allows the listed MAC addresses to associate to
the Array. All others are denied.
• Deny List: Denies the listed MAC addresses permission to
associate to the Array. All others are allowed.

In addition to these lists, other authentication methods (for
example, RADIUS) are still enforced for users.