Manual Part 2

Wireless Array
452 The Command Line Interface
quit
The quit command [MyAP(config)# quit] is used to exit the Command Line
Interface.
authentication-server
The radius-server command [MyAP(config-authserver)#] is used to configure
the external and internal RADIUS server parameters.
Command Description
<cr> Exit the Command Line Interface.
FORMAT:
quit
If you have made any configuration changes and
your changes have not been saved, you are
prompted to save your changes to Flash.
At the prompt, answer Yes to save your changes,
or answer No to discard your changes.
Command Description
external Configure an external RADIUS server.
FORMAT:
authentication-server external
To configure a RADIUS server (primary,
secondary, or accounting server, by IP address or
host name), and the reporting interval use:
authentication-server external accounting
internal Configure the external RADIUS server.
FORMAT: add active directory
authentication-server internal
use Choose the active RADIUS server (either external
or internal).
FORMAT:
authentication-server use external (or internal)