Manual Part 2

Wireless Array
248 Configuring the Wireless Array
appears after you have made a change requiring validation (i.e., entering
a new hostname or changing an existing entry to a different hostname). If
you return to this page at a later time, the checkmark will not be present.
5. Workgroup/Domain: Enter the Pre-Windows 2000 Domain name. This
can be found by opening the Active Directory Users and Computers.
Right click the domain in the left hand window and select Properties.
This will display the Domain name that should be entered.
Figure 138. Finding the Domain Name from Active Directory
6. Realm: Realm name (may be the same as the domain name). Workgroup
and Realm are both required. To find the Realm, open a command
window on the server and type
echo %userdnsdomain%
This will display the Realm.
7. Click Apply Active Directory Settings to use these settings.
8. You must click Join Domain to ask the domain controller to join the
Array to the domain. The Array is added to the list of computers in the
workgroup. The status of the request will be displayed in the area below