Manual Part 2

Wireless Array
442 The Command Line Interface
interface
The interface command [MyAP(config)# interface] is used to select the interface
that you want to configure. To see a listing of the commands that are available for
each interface, use the ? command at the selected interface prompt. For example,
using the ? command at the MyAP(config-gig1}# prompt displays a listing of all
commands for the gig1 interface.
load
The load command [MyAP(config)# load] loads a configuration file.
Command Description
console Select the console interface. The console interface
is used for management purposes only.
FORMAT:
interface console
gig1 Select the Gigabit 1 interface.
FORMAT:
interface gig1
gig2 Select the Gigabit 2 interface.
FORMAT:
interface gig2
iap Select an IAP.
FORMAT:
interface iap
Command Description
factory.conf Load the factory settings configuration file.
FORMAT:
load [factory.conf]