Manual Part 2

Wireless Array
388 Using Tools on the Wireless Array
 Web Page Redirect (Captive Portal)
 Network Tools
 Progress and Status Frames
System
1. Save & Reboot or Reboot: Use Save & Reboot to save the current
configuration and then reboot the Array. The LEDs on the Array indicate
the progress of the reboot, as described in “Powering Up the Wireless
Array” on page 66. Alternatively, use the Reboot button to discard any
configuration changes which have not been saved since the last reboot.
You may specify an optional Delay period in seconds to wait before the
reboot starts.
2. Software Upgrade: This feature upgrades the ArrayOS to a newer
version provided by Xirrus. Please note that you typically will need an
updated license key to cover the upgrade’s features before clicking the
Upgrade button. If you are a customer using XMS-9000-CL-x, your
license will be updated for you automatically; with other XMS versions,
you can easily upgrade all members of a profile network to a new
ArrayOS release. See “About Licensing and Upgrades” on page 387 for
details.
Enter the filename and directory location (or click on the Browse button
to locate the software upgrade file), then click on the Upgrade button to
upload the new file to the Array. Progress of the operation will be
displayed below, in the Progress section. Completion status of the
operation is shown in the Status section.
This operation does not run the new software or change any configured
values. The existing software continues to run on the Array until you
reboot, at which time the uploaded software will be used. An upgrade
will, however, automatically save a copy of the current configuration of
the Array. See Step 8 on page 391.