Manual Part 2

Wireless Array
Configuring the Wireless Array 363
• Enable All Links—this command activates all WDS links configured
on the Array.
• Disable All Links—this command deactivates all WDS links
configured on the Array. It leaves all your settings unchanged, ready
to re-enable.
• Reset All Links—this command tears down all links configured on
the Array and sets them back to their factory defaults, effective
immediately.
6. Client Link: Shows the ID (1 to 4) of each of the four possible WDS links.
7. Enabled: Check this box if you want to enable this WDS link, or uncheck
the box to disable the link.
8. Max IAPs Allowed (1-3): Enter the maximum number of IAPs for this
link, between 1 and 3.
9. Target Array Base MAC Address: Enter the base MAC address of the
target Array (the host Array at the other side of this link). To find this
MAC address, open the WDS window on the target Array, and use This
Array Address located on the right under the Summary of WDS Host
Links. To allow any Xirrus Array to be accepted as a WDS target, enter the
Xirrus OUI: 00:0f:7d:00:00:00 or 50:60:28:00:00:00 (this is useful for
roaming in a mobile deployment, as described in Step 2 on page 362).
10. Target SSID: Enter the SSID that the target Array is using.
11. Username: Enter a username for this WDS link. A username and
password is required if the SSID is using PEAP for WDS authentication
from the internal RADIUS server.
12. Password: Enter a password for this WDS link.
13. Clear Settings: Click on the Clear button to reset all of the fields on this
line.
WDS Client Link IAP Assignments:
14. For each desired client link, select the IAPs that are part of that link. The
IAP channel assignments are shown in the column headers.