Manual Part 2

Wireless Array
318 Configuring the Wireless Array
data about its RF environment. In this case, it will pick a set of compatible
channel assignments at random.
The following options may be selected for auto configuration:
• Negotiate: negotiate air-time with other Arrays before performing a
full scan.
• Full Scan: perform a full traffic scan on all channels on all IAPs to
determine the best channel allocation.
• Non-Radar: give preference to channels without radar-detect. See
table in “Procedure for Configuring Global 802.11an IAP Settings” on
page 311.
• Include WDS: automatically assign 5GHz to WDS client links.
6. Set Cell Size/ Autoconfigure: Cell Size may be set globally for all
802.11b/g IAPs to auto, large, medium, small, or max using the drop
down menu.
For an overview of RF power and cell size settings, please see “RF Power
& Sensitivity” on page 336, “Capacity and Cell Sizes” on page 32, and
“Fine Tuning Cell Sizes” on page 33.

On the XR-500/600 and XR-1000 Series Arrays, the Factory Defaults
button will not restore iap1 to monitor mode. You will need to restore this
setting manually. Also, you may need to set Timeshare Mode again - see
“RF Monitor” on page 334.

To use the Auto Cell Size feature, the following additional settings are
required:
RF Monitor Mode must be turned On. See “RF Monitor” on page 334
One of the radios must be in monitor mode with the default RxdBm setting
of -95, and all other IAPs that will use Auto Cell must have Cell Size set to
auto. See “Procedure for Manually Configuring IAPs” on page 291.