User Manual

The PC-2000 CLUTCH HUB PULLER for tapered shaft Pro Clutch applications consists of 4 pieces. The bolt plate,
the bolt, and 2 adaptors. The long adaptor with the deep hole is use with for 4-speed (coil spring clutch) short
shaft applications, the short adaptor is for use with for long shaft 5 speed (diaphragm spring clutch).
PC-2000 INSTRUCTIONS
PC-2000 INSTRUCTIONS
Loosen & remove the 4 shouldered nuts
as shown. Remove the clips, retainer,
diaphragm spring and pressure plate as
pictured.
Remove the clutch hub nut (left hand
threads) from the transmission main-
shaft.
Place the long adaptor with recess for
the clutch rod on the mainshaft as
shown.
Install the PC-2000 onto the transmis-
sion mainshaft as shown. Tighten
shouldered nuts snug, making sure that
the plate is flat on the 4 clutch hub studs.
Give it a sharp tap with a medium weight
steel hammer (wear safety goggles).
Turn the center bolt clockwise until it
contacts the adaptor on the mainshaft,
then another 1/4-1/2 turn.
3. Mount the puller plate on the
clutch hub studs using the 4
shouldered nuts. Make sure the
plate is seated evenly on all 4
studs. Make sure that all 4 nuts
are tight.
4. Turn the center bolt until it con-
tacts the adaptor positioned on the
mainshaft. Slowly turn the bolt
clockwise 1/4-to-1/2 turn putting
pressure on the plate. Give the bolt
a sharp tap with a medium weight
steel hammer . If needed, go anoth-
er 1/4 turn and repeat the t ap.
RIVERA
RIVERA
Engineering Inc.
Engineering Inc.
12450 Whittier Blvd, Whittier, CA 90602
[phone] fax [phone] www.riveraengineering.com
rear view
front view
front view
1
2
3
4
1. Remove the 4 shouldered
nut s, ret ainer, diaphragm
spring, & pressure plate.
2. Remove the lef t hand thread
clutch hub nut.
3. Inst all the adaptor on the
end of the trans mainshaf t.
apply anti seize to stud theads
prior to installing shoulder nuts